[UNITIKA TERRAMAC]

General properties of TERRAMAC resins

Item Test method	ISO	Unit	Basic grade TE-2000	High- impact grade TE-1030	High- impact grade TE-1070	Heat- resisting grade TE-7000	Heat- resisting grade TE-7307	Heat- resisting grade TE-7300	High- durability grade TE-8210	High- durability grade TE-8300
Appearance	-	-	Tran sparent	Opaque white	Opaque white	Opaque white	Opaque white	Opaque white	Opaque white	Opaque white
Density	1183	-	1.25	1.24	1.24	1.27	1.42	1.47	1.42	1.47
Melting point	-	°C	170	170	170	170	170	170	170	170
Breaking strength	527	MPa	63	51	34	70	54	54	50	56
Tensile elongation	527	%	4	170	200<	2	2	1	2	1
Bending strength	178	MPa	106	77	50	110	85	98	90	104
Bending modulus	178	GPa	4.3	2.6	1.4	4.6	7.5	9.5	6.8	9.3
Charpy impact strength: With notch	179	kJ/m²	1.6	2.3	5.6	2.0	2.5	2.4	4.0	2.8
Deflection temperature under load of 0.45 MPa	75	°C	58	51	54	110	120	140	120	140
Molding shrinkage	-	%	0.3~0.5	0.3~0.5	0.3~0.5	1.0~1.2	1.0~1.2	1.0~1.2	1.0~1.2	1.0~1.2

* The data above are typical values of test pieces determined by our tests,
and are not intended to guarantee the properties of resins in a particular application.

<Extrusion, blow, and foam sheet grades>

Item Test method	ISO	Unit	Basic grade TE-4000	Soft TP-4030	Foam HV-6250H
Appearance	-	-	Tran sparent	Opaque white	Opaque white
Density	1183	-	1.25	1.24	1.27
Melting point	-	°C	170	170	170
Breaking strength	527	MPa	66	50	69
Tensile elongation	527	%	5	44	2
Bending strength	178	MPa	108	71	111
Bending modulus	178	GPa	4.6	2.4	4.7
Charpy impact strength: With notch	179	J/m	1.6	2.6	1.9
Deflection temperature under load of 0.45 MPa	75	°C	59	52	120*¹
Molding shrinkage	190°C 2.16kg	g/10min	3~5	3~5	1~3

* The data above are typical values of test pieces determined by our tests,
and are not intended to guarantee the properties of resins in a particular application.
*¹ This data is a temperature shown in molding at a predetermined die temperature(110°C).
In molding with a die of a lower temperature, the temperature is approx. 60°C.