UNITIKA UNITIKA PLASTICS DIVISION
Japanese Chinese
Printing Tips
Nylon Resin U-polymer TERRAMAC Unilate Elitel
Characteristics
Properties
Machining Conditions
Annealing
Cutting direction
Example applications
Product List
 
Contact Us
 
UNILATE > Machining Conditions Top Page
[UNITIKA UNILATE]

Machining Conditions of UNILATE®

Cutting conditions
UNILATE® is a laminated material and has very little warp and dimensional change. Cut with extreme care, referring to the following table:

Machining method Examples of machining conditions
Cutting Tool
Revolution (rpm)
Feed rate (mm/min)		 Carbide chip-saw
4,000 to 4,500
2,500 to 3,500
Milling
End milling		 Tool
Revolution (rpm)
Feed rate (mm/min)		 Carbide chip/carbide end mill
500 to 5,000
200 to 500
Drilling Tool
Revolution (rpm)
Feed rate (mm/min)		 Carbide drill
1,000 (10φ)
300 to 400
Lathing Tool
Revolution (rpm)
Feed rate (mm/min)		 Carbide chip
1,000 (10φ)
300 to 400
* The above conditions may vary with machining tools and blades.

Punching conditions:

(1) Designate a hardened die.
(2) Set a clearance of about 5/100 on one side.
(3) Set a thickness to be punched up to 2 mm.
(4) Make sure that the minimum punching diameter and the distance between holes are larger than the thickness.


To Page Top